8" Carbide Brushcutter - Trimmer Blades 3pk

UNIVERSAL FIT:----------- This blade will fit any Trimmer-Brushcutter that takes a 1", 25.4mm or 20mm arbor. Our blade is built for any RPM even super high RPM Trimmers (10,000+ rpm). Manufactured with a more flexible steel as compared to the much more brittle steel found with table saw blades (table saw blades can shatter if they hit an obstacle, plus they are only built for approx. 3,450 rpm so they should never be used with Gasoline powered Garden Trimmers). The carbide tips are welded-brazed on and will not come off.------------- NOTE: sorry, but we have NO answers regarding your particular Trimmer/brushcutter. It is up to you alone to determine whether: (1) a Blade can even be attached to your Trimmer. (2) what blade attachment hardware is available for your particular Trimmer such as: fittings, blade guards, or attachments. (3) The arbor size it takes. This is the hole in the middle of the blade, sizes we offer are mentioned above and are the most standard in the industry. (4) Our blades will out perform any 40 tooth blade, as we offer over twice the aggregate cutting surface due to Two or Three times as many CARBIDE teeth. More Caribde for the same buck means VALUE and DURABILITY. Take the test challenge and see for yourself. (5) NOTE: Jagged teeth do nothing since at high RPM's, cutting material does not sink into teeth cavities, and less teeth are prone to tearing cuts with lots of seizing in limbs... only the outer teeth tips do the cutting, our blades are the smoothest cutting in the industry. Try pruning a hedge with a 40 tooth then try ours, you will see what we are saying. The CARBIDE MIX in our teeth is 2nd to none, take the test challenge.